Кабриолет Клуб България

Нека съберем колите без покрив под един покрив!
https://www.AutoDoc.Bg https://www.cabriozone.com
Дата и час: Съб Май 28, 2022 2:51 am

Часовете са според зоната UTC + 2 часа




Напиши нова тема Отговори на тема  [ 1 мнение ] 
Автор Съобщение
 Заглавие: wax lost investment casting
МнениеПубликувано на: Чет Май 05, 2022 9:34 am 
Offline
любител

Регистриран на: Чет Май 05, 2022 9:17 am
Мнения: 4
When using wax to make patterns, investment casting is also called "lost wax casting". Investment casting usually refers to making a pattern in a fusible material, coating the surface of the pattern with several layers of refractory material to make a mold shell, and then melting the pattern out of the mold shell to obtain a mold without parting surface. A casting solution that can be filled with sand. Because patterns are widely made of waxy materials, investment casting is often referred to as "lost wax casting".
The types of alloys that can be produced by investment casting include carbon steel, alloy steel, heat-resistant alloys, stainless steel, precision alloys, permanent magnet alloys, bearing alloys, copper alloys, aluminum alloys, titanium alloys, and ductile iron.
The shape of investment castings is generally more complex, the minimum diameter of the holes that can be cast on the castings can reach 0.5mm, and the minimum wall thickness of the castings is 0.3mm. In production, some parts that were originally composed of several parts can be designed into integral parts by changing the structure of the parts and directly cast by investment casting, so as to save processing time and consumption of metal materials, and make the part structure more accurate. to be reasonable.
The weight of investment castings is mostly zero to dozens of Newtons (from a few grams to more than ten kilograms, generally no more than 25 kilograms), and it is more troublesome to use the investment casting method to produce too heavy castings.
The investment casting process is complicated and difficult to control, and the materials used and consumed are more expensive, so it is suitable for the production of small parts with complex shapes, high precision requirements, or difficult to perform other processing, such as turbine engine blades.


Върнете се в началото
 Профил  
 
Покажи мненията от миналия:  Сортирай по  
Напиши нова тема Отговори на тема  [ 1 мнение ] 

Часовете са според зоната UTC + 2 часа


Кой е на линия

Потребители разглеждащи този форум: 0 регистрирани и 1 госта


Вие не можете да пускате нови теми
Вие не можете да отговаряте на теми
Вие не можете да променяте собственото си мнение
Вие не можете да изтривате собствените си мнения

Търсене:
Иди на:  
cron
POWERED_BY
Хостинг